Use and Care Manual

MAINTENANCE

1. Turn off the power switch in the control panel.

2. Unplug the unit and let it cool completely.

3. To keep the heater clean, the outer shell may be cleaned with a soft, damp cloth. You

may use a mild detergent if necessary. After cleaning, dry the unit with a soft cloth.

CAUTION: DO NOT let liquid enter the heater.

4. DO NOT use alcohol, gasoline, abrasive powders, furniture polish, or rough brushes to

clean the heater. This may cause damage or deterioration to the surface of the heater.

5. DO NOT immerse the heater in water.

6. Wait until the unit is completely dry before use.

7. If you do not use the heater for a long time, please take out the remote batteries (to

prevent corrosion) as shown below. Store the remote in a safe place.

STORAGE

Store the heater in a cool, dry location when not in use. To prevent dust and dirt build-up, use the

original packaging to repack the unit.

BASIC TROUBLESHOOTING

If the heater will not operate, please check the following before seeking repair advice:

1. Check if the power cord is plugged into an electrical outlet, if not, plug in.

2. Check to see if the battery on the remote is placed correctly, undamaged.

NOTE: For the heater to function properly, the desired temperature on the heater must be

set a few degrees higher than the temperature in the room. If the seems to not be heating,

increase the desired temperature on the heater to engage the heat elements.

PUSH

lid

Battery

PAGE 1
MAINTENANCE 1. Turn off the power switch in the control panel. 2. Unplug the unit and let it cool completely. 3. To keep the heater clean, the outer shell may be cleaned with a soft, damp cloth. You may use a mild detergent if necessary. After cleaning, dry the unit with a soft cloth. CAUTION: DO NOT let liquid enter the heater. 4. DO NOT use alcohol, gasoline, abrasive powders, furniture polish, or rough brushes to clean the heater. This may cause damage or deterioration to the surface of the heater. 5.