Installation Guide

All transition pieces should be attached to the subfloor using the track supplied with the molding, or
glue down using a contractor high grade adhesive, dependent on the transition purchased. If adhered,
be sure the transition sits firmly in the adhesive, and take care not to get any adhesive on the flooring.
Remove any adhesive from the surface immediately with mineral spirits and buff off any residue with a
dry soft cloth. It may be necessary to place heavy weights on the transition until the adhesive dries to
ensure it will lay flat. Never attach the transitions directly to the flooring.
Finishing the Job:
Inspect your work, as it will cost you more if you have to come back to do a repair later. Replace
original baseboards, or install matching hardwood baseboard. Install matching transitions as needed
or recommended by your dealer or installer. It is not recommended or necessary to seal this floor after
installation. Protect your floor from scratches by using felt pads on chair legs or furniture feet. Plastic
rollers/castors can damage your flooring; if necessary try to replace with softer rubber wheels/castors.
When moving heavy items like refrigerators, use at least two sheets of 1/4" Masonite or plywood while
moving (sliding the appliance from one sheet to the next) to protect the flooring against scratching
and denting.
Congratulations!
You have just installed a beautiful and elegant Wellmade Floor!
092016DZ