Owner's Manual (Complete)

Chapter 10—Programs and the Visual Programmer
14 The Home Control Assistant
At the bottom of the dialog is a dropdown where you can select the type of trigger you want to add.
In this example, a UPB trigger is being added.
Each trigger type has different properties and is shown in the next sections.
Hint: The Snippet Wizard can construct a series of Test elements to see what trigger started the
program.
X10 Reception triggers
In the Address portion of the dialog is specified the house and unit code. This can be done in four
possible ways:
 Select the house and unit code
 Select the house and unit code assigned to a controller. If the controller has multiple
units, for example a multi-button keypad, select which unit of the controller to use. The
individual units are show as the name of the controller followed by a colon then a number.
 Select the house and unit code assigned to another device.
 Select a group
The first case is simplest. All you need do is to pick a house and unit code.
The next two options have a special behavior. If the X10 address of the device or controller is
changed, then this trigger for the program also changes.
For example, assume you created a trigger and selected the “Use the address of this controller”
option. The controller selected was “Keypad Entry:2” and “Keypad Entry” has a X10 address of