Owner's Manual (Complete)

Chapter 10—Programs and the Visual Programmer
The Home Control Assistant 15
L7. This would assign to this program a trigger of whose address is L8. If the keypad was later
changed to D2, the trigger address automatically changes to D3.
The last case is a lot like assigning a trigger address using a device or controller. In the case of
selecting a group, the address of any of the device or controller members of the group is the
address of the trigger. For example, assume you have a group called Lamps. Also assume that in
this group are three devices whose addresses are C1, D1, and E9. If you create a trigger and chose
the group address option and select group Lamps, then the address part of the trigger are the
addresses C1, D1, and E9. If you change the address of any of the group members, or add or
remove members from the group, the addresses for this trigger changes also.
In the lower group of this dialog you specify the command that must follow the address to trigger
the program. Listed here are all the X10 commands. You can also choose a specific preset dim
level or a range of levels that trigger the program. The final option of the command list is, in
effect, no command. If you choose this option the program triggers when the address selected is
received regardless of what command, if any, follows.