Owner's Manual (Complete)

Chapter 20—Control User Interface
8 The Home Control Assistant
But what if you want to just control the load attached to the switch? What if the switch paddle
sends a UPB link or an Insteon scene that controls other devices but all you want is to control just
the load connected to the switch? From the Control Interface you can do that as well.
Take a look at this example:
This example is from a long tap on the Down Bath Ceiling Light icon. The popup control panel
has both the glass keypad – the bigger on/off buttons at the left - and also the on/off/dim controls
for the load at the right. You can control just the load by using the controls on the right or you can
“tap” the switch paddle using the controls on the left.
Hint: If the switch doesn’t transmit anything when you use the switch paddle – that is you don’t
have a UPB link or Insteon scene programmed into the switch – then using the left or right
controls have the same effect.
But for some devices you may not want a glass keypad but only the load controls. Or sometimes
you want to see only the glass keypad and no load controls. And finally, sometimes you want both
the load controls and they glass keypad. The Control Interface is configurable for this in this
manner.