Use and Care Manual

INSTALLATION
1. Do not install tire swing over concrete, asphalt, packed earth, or any other hard surface.
See pages 6 for more information on proper protective surfacing material.
2. Confirm that the supporting structure is secure, it will support at least 200 pounds, is
over level ground, and is no less than 6 ft. from vertical elements on all sides.
3. Tree Limb Ass embl y
• Test tree limb to ensure that it will hold the weight limit of 200 lbs. safely.
• Form a small noose at one end of your rope and throw it over the tree limb.
• Run the other end of rope through the noose you created and tighten firmly.
• Run the end of rope through the loop on the tire swing.
• Tie a minimum of TWO tight knots firmly. Bottom of swing should be no less than 8
inches from ground. See figure 2.
• 4. Swing Set or other Horizontal Beam Assembl y
Attach the tire swing to a swing set by removing one set of chains from an existing swing
and attach the upper loop (above the PVC separator bar) to the chain support hook on the
underside of the swing set crossbar. Then close the hook. See figure 1.
Allow 6 ft. of clearance on each side of the swing from stationary objects or other swinging
elements of any kind. Bottom of swing should be no less than 8 inches from ground. See
figure 2.
More Fun Products f r o m
Pony P al Tire Swing - MM00107 Tractor R ide ’ n Tire Swing - MM00108
Air R iderz
Ex tr eme
MM00118
Open hook
and hang swing
Close hook
Big B uck Tire Swing - MM00114
PVC spreader bar
Figure 1
2
Chopper R ide ’ n Tire Swing - MM00117
www.mandmsalesinc.com
7
Air R iderz
with D isk
MM00128