Instructions / Assembly

Page 20 of 72
3.3. ATTACH RAMP LEGS TO RAMPS
3.3.1. Locate the appropriate PRLxxPR (RAMP LEG PAIR where xx denotes the leg length) for the
location. Insert the leg into a foot. Make sure the leg is fully engaged in the foot and the
foot will be oriented so it extends under the ramp once installed. Tighten the thumb
screw on each foot securely (FIG. 3.5).
If installing on soft soil it may be necessary to set the foot on a concrete pad.
FIG. 3.5
3.3.2. Place the slot in the ramp leg over the two shorter studs in the middle of the center
saddle bracket install 5/16”-18 nylon insert locknuts and 5/16” flat washers on each stud
but do not tighten fully. Repeat on the opposite side (FIG 3.5 and FIG 3.6).
In situations where the lower end of a ramp or ramp run is too close to the ground
to install normal feet and feet are needed due to ground or other conditions, special
welded low profile feet (part no. PRLPRLP). are available (FIG 3.6).
3.3.3. Remove the 5/16”-18 nylon insert locknuts and 5/16” flat washers attaching the ramp
handrail post (if already installed), position the low profile foot so the foot is oriented
under the ramp and the channel leg wraps around the ramp post. Reinstall the locknuts
and flat washers, adjust height as described below then tighten fasteners securely.
Repeat on the opposite side (FIG. 3.6).