Warranty

Three Wire Float Switches Series 2359
[e-mail]
Call us at: 314-787-8059
www.SumpAlarm.Com
REV 0228
Thank you for your float switch purchase!
Always remember to disconnect all power and have your float switch installed by a licensed electrician.
This float switch is rated to directly control motors of up to ½ Horsepower (or 13 Amps) at 120 or 220 Volts AC for non-continuous pump
operations, and up to 13 Amps DC for motor loads. Please feel free to contact us for other applications. For higher horsepower motors, a
contactor or relay will be required. Your float switch has a three wire configuration, which can be used to make connections for either filling or
emptying.
- For “Normally Full” Operation, where the desire to activate a pump to Fill a tank, sump, or vessel, use the Black and Blue Wires for
connection, and cap the Brown wire.
- For “Normally Empty” Operation, where the desire to activate a pump to Empty a tank, sump, or vessel, use the Black and Brown
Wires for connection, and cap the Blue wire.
Installation #1
Without
Counterweight
The above diagrams demonstrate a float switch
utilizing the counterweight included in the
package. A counterweight may not be
necessary in your particular installation. In
submersible pump applications, a float switch
can be mounted as shown at left using only a
wire tie. The Tether Length illustrated in the
Figure can be minimized to 3 inches from the
float switch ribbing.
Instalation #2
With
Counterweight
Alternatively, if the float switch is installed with
the counterweight, it will be necessary to slide
the cord grip down the length of the cable. This
can be accomplished by opening the cord grip
with a screwdriver and passing it down the
length of the cable. After the cord grip is in
position,
the
counterweight can be slid down the cable and
locked to the cord grip.
THE FLOAT SWITCH IS RATED FOR POTABLE WATER, HOWEVER THE CABLE WEIGHT IS NOT
OTHER FLOAT SWITCH RATINGS AND SPECIFICATIONS
 YOUR FLOAT SWITCH IS WARRANTED IN THE FIELD FOR THREE YEARS.
 TEMPERATURE RATINGS FROM 32F TO 140F, AND RATED TO IP68, WITH CE APPROVALS
 STAINLESS STEEL BALL AND HONEYWELL MICRO SWITCH
 CASING MADE OF POLYPROPYLENE FOR NON-CORROSIVE AND NON-COMBUSTIBLE FLUIDS
 IT CAN BE USED IN WATER TANKS, LOW DENSITY OILS AND SEWAGE WATER
 NOT RATED FOR HAZARDOUS OR EXPLOSIVE APPLICATIONS.
 IEC 60730-1 (08-2003) + IEC 60730-2-16 (08-2001)
 THE FLOAT SWITCH IS RATED FOR POTABLE WATER, HOWEVER THE CABLE WEIGHT IS NOT