Instructions / Assembly
Steps to Complete Kitchen Faucet Install
TOOLS NEEDED FOR ASSEMBLY
(not included)
Crescent Wrench
Phillips
Quesons, problems, missing parts? Before returning to your retailer, write our customer service department at: Topia, Inc.,
An: Product Support, 3533 E. Corona Ave., Phoenix, AZ, 85040, USA.
Add plate which
is included
Hot & Cold Hoses
Pull-Out Hose
Weight & Screws
Pull-Out Hose
Quick Connector
Quick Connector
Hot &
Cold Hoses
Plate included
Lock Nut and Screws
Metal Washer
Rubber Washer
Pipe
Pull-Out Hose
O-Ring
Quick Connector
Hot & Cold Hoses
Assembly with plate
Pipe
TYPE ONE ASSEMBLY
• Make sure water source is completely shut o.
• Screw the pipe on to the faucet. Fasten hot and cold
exible hoses into the water supply holes on the bottom
of the faucet if necessary.
• Carefully lower the faucet through the panel and
counter hole.
• Slide the rubber washer and the 1.5-inch metal washer
and lock nut onto the pipe and tighten the fastener.
• Connect pull-out hose with quick connector. Assemble
the weight and screws on the pull-out hose, then connect
to the supply line source. The exible hose on the right
should be attached to the cold water supply line. The
exible hose on the left should attach to the hot water
supply line. Tighten these connections accordingly.
• With the faucet’s lever wide open, slowly turn the
handles on the hot and cold water supply lines to the
open position until the desired ow rate is achieved.
Allow the faucet to run for a few minutes to get rid of
any air pockets.
Applicable for the following faucet series:
TKF-022ORB TKF-022BN