SDS

Material Safety Data Sheet
Report No.:STR13078154S Page 5 of 10
SEM.Test Compliance Service Co., Ltd.
3/F,Jinbao Commerce Building, Xin'an Fanshen Road,
Bao'an District, Shenzhen, P.R.C
Section 6 – Accidental Release Measures
Personal Precautions, protective equipment, and
emergency procedures
Restrict access to area until completion of
clean-up. Do not touch the spilled material. Wear
adequate personal protective equipment as
indicated in Section 8.
Environmental Precautions Prevent material from contaminating soil and
from entering sewers or waterways.
Methods and materials for Containment Stop the leak if safe to do so. Contain the spilled
liquid with dry sand or earth. Clean up spills
immediately.
Methods and materials for cleaning up Absorb spilled material with an inert absorbent
(dry sand or earth). Scoop contaminated
absorbent into an acceptable waste container.
Collect all contaminated absorbent and dispose
of according to directions in Section 13. Scrub
the area with detergent and water; collect all
contaminated wash water for proper disposal.
Section 7 – Handling and Storage
Handling Do not dismantle, open or shred secondary
Li-ion Polymer Battery Pack;
Don’t handling Li-ion Polymer Battery Pack with
metalwork. Do not open, dissemble, crush or
burn battery. Ensure good ventilation/
exhaustion at the workplace.
Prevent formation of dust.
Information about protection against explosions
and fires: Keep ignition sources away- Do not
smoke.
Storage If the Li-ion Polymer Battery Pack is subject to
storage for such a long term as more than 3
months, it is recommended to recharge the
Li-ion Polymer Battery Pack periodically.
3 months: -10℃~+40℃, 45 to 85%RH
And recommended at 0℃~+35℃ for long period
storage.
The capacity recovery rate in the delivery state
(50% capacity of fully charged) after storage is
assumed to be 80% or more.
The voltage for a long time storage shall be
3.7V~4.2V range.
Do not storage Li-ion Polymer Battery Pack
haphazardly in a box or drawer where they may
SEM. Test Compliance