Installation Manual

PRE-INSTALLATION NOTES
[phone] www.undercoverinfo.com
TONNEAU INSTALLATION GUIDE
INSTALLATION KIT CHECKLIST
A
B
J
C
G
H
D
I
E
F
A: Hydraulic Struts
B: J-Hooks & Wall Mounting Screws
C: 6 UtiliTrac Flat Clamps
D: Stainless Steel Bolts 5/16” x 1“
E: Spiral Rings
F: Stainless Steel Washers 5/16”
G: Stainless Steel Lock Washers 5/16”
H: Ball Stud Bracket
I: Forward Mounting Brackets
J: Rear Mounting Brackets
Actual Bolt Size
1-inch x 5/16”
Model 4050 Toyota Tacoma Quad Cab 2005–Current w/Multi-Track System
Page 1
FORM # IG4050
Modified April 2005
Be sure to use only cleaners,waxes, etc., which are labeled “safe for use on plastics”. Make sure that chemicals or substances,
which are not labeled “safe for plastics”, do not come in contact with your Undercover. Failure to do so could cause discoloration
and/or structural damage to your Undercover and will void your warranty.
Paint rubbing of the truck is normally not a problem,but is always a possibility with any tonneau. To ensure less chance of
possible paint rubbing of the truck, it is suggested to install a tailgate protector and adhere Cab Skin®,Scotch Cal®, or similar
product to the truck bed.These products can provide added assurance against paint rubbing.
Undercover Tonneaus are designed from trucks that do not have a bed liner (spray-in bed liners pose no problem).Trucks that do
have under-the-rail or over-the-rail bed liners will require some minor trimming of the bed liner to ensure proper placement of
the mounting brackets. Due to the wide variety of bed liner manufacturers, the modifications will vary slightly between different
brands.Any modifications must be made to the bed liner and NOT to the Undercover mounting hardware.Modifications to the
mounting hardware will result in improper installation and will void your warranty.
1
2
3