SDS

UNICORN SPIT - HANDY ART (VARIOUS COLORS)
Section 8. Exposure controls/personal protection
Hand protection
Use a properly fitted, air-purifying or air-fed respirator complying with an approved
standard if a risk assessment indicates this is necessary. Respirator selection must be
based on known or anticipated exposure levels, the hazards of the product and the safe
working limits of the selected respirator.
Chemical-resistant, impervious gloves complying with an approved standard should be
worn at all times when handling chemical products if a risk assessment indicates this is
necessary.
Safety eyewear complying with an approved standard should be used when a risk
assessment indicates this is necessary to avoid exposure to liquid splashes, mists,
gases or dusts. If contact is possible, the following protection should be worn, unless
the assessment indicates a higher degree of protection: safety glasses with side-
shields.
Eye/face protection
Respiratory protection
:
:
:
Body protection
Personal protective equipment for the body should be selected based on the task being
performed and the risks involved and should be approved by a specialist before
handling this product.
:
Environmental exposure
controls
:
Emissions from ventilation or work process equipment should be checked to ensure
they comply with the requirements of environmental protection legislation. In some
cases, fume scrubbers, filters or engineering modifications to the process equipment
will be necessary to reduce emissions to acceptable levels.
Wash hands, forearms and face thoroughly after handling chemical products, before
eating, smoking and using the lavatory and at the end of the working period.
Appropriate techniques should be used to remove potentially contaminated clothing.
Wash contaminated clothing before reusing. Ensure that eyewash stations and safety
showers are close to the workstation location.
Hygiene measures
:
Individual protection measures
Skin protection
Other skin protection
:
Appropriate footwear and any additional skin protection measures should be selected
based on the task being performed and the risks involved and should be approved by a
specialist before handling this product.
Section 9. Physical and chemical properties
Physical state
Vapor pressure
Specific gravity
Vapor density
Solubility
Liquid.
1.17
>1 [Air = 1]
2.7 kPa (20 mm Hg) [room temperature]
Easily soluble in the following materials: water
Jasmine-like.
Odor
pH
Various
Color
Evaporation rate
<1 (ether (anhydrous) = 1)
Flash point
Not available.
Not available.
Viscosity
Not available.
:
:
:
:
:
:
:
:
:
:
:
Appearance
Boiling point
:
>100°C (>212°F)
Lower and upper explosive
(flammable) limits
:
Not available.
Flammability
:
Non-flammable.
VOC (wt%)
:
0.269875%
Date of issue/Date of revision
:
3/27/2017
4/7