Owner's Manual

ManualsBrandsUniden ManualsTelephonesCEZ202

Connecting the Phone

To reduce the risk of re, use only No. 26 AWG or larger

(e.g., 24 AWG) UL listed or CSA Certied Telecommunications

Line Cord.

Test the connection

1) Pick up the handset and listen for a dial tone. If you don't hear

one, check the connection between the base and the phone jack.

2) Make a test call. If the dial won't stop when you dial, check the

Tone/pulse switch: if it’s on tone, change it to pulse, and vice

versa. Try your test call again.

If static or noise is on the line, see the section on Solving Problems.

Use the coiled cord to

connect the handset

to the base (use the

jack marked with the

handset icon).

Use the telephone

cord to connect the

line jack to a standard

telephone wall jack.

Route the

cord through

the channel.

Route the

cord through

the channel.

Summary of content (6 pages)

PAGE 1
Connecting the Phone Route the cord through the channel. Use the telephone cord to connect the line jack to a standard telephone wall jack. Use the coiled cord to connect the handset to the base (use the jack marked with the handset icon). Route the cord through the channel. To reduce the risk of fire, use only No. 26 AWG or larger (e.g., 24 AWG) UL listed or CSA Certified Telecommunications Line Cord. Test the connection 1) Pick up the handset and listen for a dial tone.
PAGE 2
FCC Part 15 Information This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
PAGE 3
Slimline Phone User's Guide What's in the box? Handset Base Coiled handset cord Telephone cord If any items are missing or damaged, contact our Customer Care Line immediately. Never use damaged products. Need Help? You can get answers 24/7 at our website: www.uniden.com. If You... Contact Uniden’s...
PAGE 4
Using the Phone Boost button Volume dial Flash button Tone/pulse switch Visual ringer light Reset button Mute button Hook Redial switch button Handset clip Ringer switch Button Boost and Volume dial Flash Tone/pulse Reset Mute Redial Ringer What it does These controls work together to change the volume. See Changing the Audio Volume. During a call: switch to a waiting call Change the dial mode (see Solving Problems.) During a call: Hang up the current call and get a dial tone.
PAGE 5
Wall-Mounting the Phone You can mount the phone on any standard telephone wall plate where the pins are Connect the cords as usual, but route the 100 mm (315/16 inches) line cord through apart. the inside channel. Before putting the handset in the cradle, you need to switch the handset Tuck excess line cord into the clip into space on the back of the phone. wall mount mode as shown in Line up the notches on the the drawing base with the pins on the below. wall plate.
PAGE 6
If there's static on the line DSL broadband Internet service can cause static on telephones, but a DSL filter usually solves any problems. To get a DSL filter, call your DSL provider or look in any electronics store. To install the filter, plug the DSL filter into the wall jack and then plug your phone into the filter. Make a test call to see if the noise is gone.