WDECT3305 Accessory handset for WDECT3315 and WDECT3355 Series OWNER’S MANUAL
Welcome Congratulations on your purchase of this Uniden WDECT3305 accessory handset and charger. This additional handset is for use with the Uniden WDECT3315 and WDECT3355 base. You can place a fully featured cordless handset anywhere in your home where AC power is available to connect the handset charging cradle. The WDECT3315 and WDECT3355 bases will support up to 4 handsets. Caution: The earcap of this telephone may attract and retain small metallic objects.
Connect the Charger 1 Connect the AC adapter to the DC IN 9V jack and to a standard AC wall outlet. the charger on a 2 Set desk or tabletop, and place the handset in To AC outlet the charger with the keypad facing forward. 3 AC adapter (supplied) To DC IN 9V Make sure the charge LED illuminates. If the LED does not illuminate, check to see that the AC adapter is plugged in and that the handset makes good contact with the charger charging contacts. • Use only the supplied AC adapter.
5 Place the handset in the charging cradle with the keypad facing forward. • Use only the Uniden battery (BT446) supplied with your phone. Replacement batteries are also available through the nearest Uniden dealer. (See page 1.) • Recharge your handset on a regular basis by returning the handset to the charger after each phone call.
Register the Handset You need to register the WDECT3305 to the main base before use! If the WDECT3305 has not been registered before then the display will show.... ‘Place handset on main base to register’ The WDECT3305 must show this display before proceeding to the registration procedure. If the WDECT3305 was de-registered from another base, select ‘System Reset’ from handset menu then select ‘Replacing Base’ and select ‘Yes’. The above display will then show.
3 While the handset is registering, ‘Handset Registering’ will appear WDECT3305 Handset in the LCD. + 3 When ‘Registration Main Base Complete’ is displayed, the handset has been registered to the base. If ‘Registration Failed’ appears, please try these steps again. Handset Registering Registration Complete • The handset can be registered when the main base is in standby mode. • Standby Mode - The handset is not in use and has not been pressed.
Warranty ONE YEAR LIMITED WARRANTY UNIDEN WDECT3305 ACCESSORY CORDLESS PHONE IMPORTANT : WARRANTOR : Evidence of original purchase is required for warranty service. Uniden Australia Pty Limited A.B.N. 58 001 865 498 Uniden New Zealand Limited Warranty only available in original country of purchase.
© 2007 Uniden Australia Pty Limited Uniden New Zealand Limited Printed in China UUZZ01642BZ(0) [*]