Assembly Instruction

1of3

Package Contents

Warnings and Cautions

Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.

These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We strongly

recommend that a licensed, professional electrician perform the installation.

Disconnect fixture from power source before replacing bulbs. Make sure bulbs are given sufficient time to cool before removal.

Fixture Loop

with Side Rods

Upper Tier

Hardware Contents

Crossbar

Assembly

Ceiling

Canopy

Fixture Chain

Quick Link

(15)B10CandelabraBasebulbs60WMaximumor

(15)CandelabraBaseT8Vintage bulbs are recommended but not supplied.

20-30minutes

Identifyandinspectallpartsbeforebeginninginstallation.Checkpackagecontentlistanddiagramsbelowtoensureallpartsare

present.Ifanypartsaremissingordamaged,donotattempttoassemble,install,oroperatethefixture.Contactcustomerserviceforreplacement

parts.

LightSource:

EstimatedAssemblyTime:

Preparation:

ToolsRequired: Flathead screwdriver, Phillips screwdriver, pliers, wire cutters, wire strippers, electrical tape, safety glasses.

Bottom Tier

STEP 1 Install Fixture Loop with Side Rods, Upper Tier, Medium

Tier and Bottom Tier together

A. Attach side rods on the Bottom Tier (D) and side rods on the Top Tier

(B) to the loops in the Medium Rod (C).

B. Carefully pull supply wires and ground wire through the Fixture Loop

with Side Rods (A) and attach side rods of Fixture Loop with Side

Rods (A) to loops in the Upper Tier (B).

Medium

Tier

TOP VIEW

Side Rod

Loop

Supply Wires and

Ground Wire

Figure 1

Loop

Assembly Instruction

PAGE 1
Assembly Instruction Tools Required: Flathead screwdriver, Phillips screwdriver, pliers, wire cutters, wire strippers, electrical tape, safety glasses. Light Source: (15) B10 Candelabra Base bulbs 60W Maximum or (15) Candelabra Base T8 Vintage bulbs are recommended but not supplied. Estimated Assembly Time: 20-30 minutes Preparation: Identify and inspect all parts before beginning installation. Check package content list and diagrams below to ensure all parts are present.
PAGE 2
STEP 2 - Install the Crossbar Assembly to Outlet Box and Adjust the length of the Nipple STEP 4 - Making the Wire Connections A. Attach the Crossbar Assembly (AA) to the Outlet Box with the head of the Green Ground Screw facing you. Secure it with Outlet Box Screws (not included), tighten until snug . B. Adjust the hex nut and lock washer underside of the crossbar to the middle of the nipple. C. Remove the canopy lock ring from the canopy chain loop.
PAGE 3
NOTE: ALL DIMENSIONS ARE ROUNDED UP TO THE NEAREST 1/4" FINISH: MOTTLED BLACK 5” Dia. 142.5” OVERALL HEIGHT ( INCLUDES 96” CHAIN AND 2 QUICK LINKS ) 40.75" 38.5” Dia.