User Manual

- 37 -
When you have slid the laminating pouch several
centimetres into the slot
t
, it will start to be pulled
in automatically. Release the laminating pouch
as soon as you notice it being pulled in auto-
matically.
 Ensure there is at least 30 cm of open space
in front of the laminator. If you do not, the
laminating pouch will not be completely
ejected from the laminator after lamina-
tion. This could damage the laminated
pouch.
The completed laminated pouch is ejected from
the pouch ejector slot
a
of the laminator.
 Only after hot lamination:
When the finished laminated pouch is dis-
charged from the pouch ejector slot
a
of
the appliance, it is hot and can easily
change its shape. For this reason, allow
the laminated pouch to cool down for at
least one minute before touching it.
To improve the lamination result, you can
weigh a still hot laminated pouch down with
a book, a file folder or any other heavy,
flat object. This helps achieves a flat and
flawless surface.
11. Anti-Blocking Switch (ABS)
At the start of the lamination process, the pouch
may be pulled in at an angle or jam itself inside the
appliance.
 Turn the anti-blocking switch (ABS)
o
to the
position ABS.
• The laminate pouch is not pulled any further in.
 Remove the laminate pouch.
 Turn the anti-blocking switch (ABS)
o
back to
the desired foil thickness.
 Re-start the lamination process.
12. Trimming function
Should you wish to use the trimming function on the
pouch guide
q
, dismantle the pouch guide
q
.
 When necessary, fold in the document
supports
s
.
 If not already done, place the trimming attach-
ment
d
so that it forms a level surface with the
pouch guide
q
.
 Slide the cutting head
e
to the end stop (the
cutting head
e
can be slid to both ends of the
cutting rail
w
).
 Flap the cutting rail
w
upwards with the rounded
grip and position the document on the pouch
guide
q
. Restrain the document by sliding the
pouch format locks
r
together until they touch
both sides of the document.
 Use the markings on the measurement table to
align the document precisely.
 Flap the cutting rail
w
downwards so that it
engages.
 Hold the paper in a secure position with your
left hand.
 To trim, press the cutting head
e
down with
the right hand and then slide it with one pull or
push over the document.
IB_67173_ULG350A1_LB5 24.06.2011 9:59 Uhr Seite 37