User Manual

Page 13

DMS-1200 SYSTEM CONFIGURATION

System Configuration for Internal LAN Network

Follow the steps below to connect a DMS-1200 to a LAN network.

1. Connect the Internet to the coaxial CABLE port in the rear of the

cable modem.

2. Plug in a RJ-45 ethernet connector cable via the Ethernet port of

the cable modem to the WAN port of the Router.

3. Connect a second RJ-45 cable to a LAN port of the Router and

plug the other end to the LAN 10/100 port on the rear of the

MFS-8/MFSPOE-8 network Switch.

4. Connect a third RJ-45 cable to connect the DMS-1200 LAN port to

one of the eight 10/100 Smart ports.

5. Plug the power supply to the DMS-1200 and then plug it in to an

unswitched AC outlet.

6. Connect a digital coax cable from the DVD player to the coaxial

digital input on the rear of the DMS-1200.

7. Connect a PC computer to the same LAN as the DMS-1200 or plug

an ethernet cable directly to the LAN port of the DMS-1200. Now the

computer can control and adjust the manufacturer’s audio control

program.

Select audio INPUT source and OUTPUT zone, MAC address etc.

This function selects input source channel and INPUT gain level

and data sent to audio equipment.

After selecting the output zone, adjust the zone limit power rate and

zone power ON/OFF and source signal INPUT channel.

Adjust the amplifier volume level per each zone for proper sound

output and maximum limitation volume level.

Turn on the ramp up volume level and adjust the equalizer repertory

and low volume loudness control effectiveness and custom Equalizer align.

nternet

able Modem

WiFi Router

FS-8

DMS-1200

DVD