Owner manual
Table Of Contents
- Welcome To Your THZ-100 Thermostat
- Installing Your THZ-100 Thermostat
- Wiring Your THZ-100 Thermostat
- Definitions
- Single Stage Furnace and Single Stage A/C
- Dual Stage Furnace and Dual Stage A/C
- Single Stage Heat Pump with Reversing Valve O
- Single Stage Heat Pump with Reversing Valve B
- Dual Stage Heat Pump with Reversing Valve O
- Dual Stage Heat Pump with Reversing Valve B
- Boiler and A/C with Separate Transformers
- First Stage Radiant Floor Heat, Second Stage Furnace with Single Stage Cooling and External Pilot Duty Relay
- Operation For Your THZ-100 Thermostat
- Thermostat Display Information
- Changing the Heating Temperature (Temperature Override)
- Changing the Cooling Temperature (Temperature Override)
- Auxiliary Heat
- Emergency Heat
- Password Protection
- Programs
- Options
- Climate Modes
- Changing the Fan Modes
- Accessing Temperature Sensor Information
- Turning Emergency Heat On or Off
- Changing the Auxiliary Heat Offset Temperature
- Changing the 2nd Stage Offset Temperature
- Resetting the Filter Reminder
- Turning the Password Protect Feature On or Off
- Changing the LCD Screen Options
- Viewing THZ-100 Thermostat Information
- Setting the Date and Time
- Discovery Mode
- Troubleshooting Thermostat On-Screen Notifications
- Resetting the THZ-100 hermostat
Page 20
THZ-100 THERMOSTAT
Selecting Hold for Time
If you desire to hold a particular desired temperature for a specific
period of time, use the arrow keys to move the highlight bar to Hold
for Time.
Press the key below the OK key label in the smart-key label at the
bottom right of the display to select this new mode. If you decide
to cancel the operation then press the key below the Go Back key
label in the smart-key label at the bottom left of the display.
If you select Hold for Time, the screen updates to the Set Hold-To
Time display with the current time displayed. Use the Up or Down
arrows to set the time period that you want to hold the desired
temperature. The Up and Down arrows changes the time in 30
minute increments. The maximum hold time is 24 hours.
When you have selected the desired time press the key below the
Enter key label in the smart-key label at the bottom right of the
display to select this new mode. If you decide to cancel the
operation then press the key below the Cancel key label in the
smart-key label at the bottom left of the display.
Alternately, if you let the programs screen time out with Hold for
Time highlighted, by the highlight bar, the hold mode is selected
and the screen updates to the Set Hold-To Time display.
On the main screen Hold to with the desired hold to time is
displayed above the current temperature information.