Owner manual
Table Of Contents
- Welcome To Your THZ-100 Thermostat
- Installing Your THZ-100 Thermostat
- Wiring Your THZ-100 Thermostat
- Definitions
- Single Stage Furnace and Single Stage A/C
- Dual Stage Furnace and Dual Stage A/C
- Single Stage Heat Pump with Reversing Valve O
- Single Stage Heat Pump with Reversing Valve B
- Dual Stage Heat Pump with Reversing Valve O
- Dual Stage Heat Pump with Reversing Valve B
- Boiler and A/C with Separate Transformers
- First Stage Radiant Floor Heat, Second Stage Furnace with Single Stage Cooling and External Pilot Duty Relay
- Operation For Your THZ-100 Thermostat
- Thermostat Display Information
- Changing the Heating Temperature (Temperature Override)
- Changing the Cooling Temperature (Temperature Override)
- Auxiliary Heat
- Emergency Heat
- Password Protection
- Programs
- Options
- Climate Modes
- Changing the Fan Modes
- Accessing Temperature Sensor Information
- Turning Emergency Heat On or Off
- Changing the Auxiliary Heat Offset Temperature
- Changing the 2nd Stage Offset Temperature
- Resetting the Filter Reminder
- Turning the Password Protect Feature On or Off
- Changing the LCD Screen Options
- Viewing THZ-100 Thermostat Information
- Setting the Date and Time
- Discovery Mode
- Troubleshooting Thermostat On-Screen Notifications
- Resetting the THZ-100 hermostat
Page 22
THZ-100 THERMOSTAT
Options
On the main thermostat display, there are three smart-key labels at
the bottom of the screen identifying the operation of the three keys
below the display. The left button is Options, the center key is
Programs, and the right key is Hold. To change between various
thermostat options, press the Options key.
The screen updates to show the list of available options as described
below.
Climate Modes
If you desire to change the HVAC system equipment mode between
Cooling, Heating, Auto (system will automatically change between
cooling and heating) or OFF enter the Options menu then access
the Climate Modes sub menu as described below. The current state
of the system is displayed in the right column.
Press the key below the OK key label in the smart-key label at the
bottom right of the display to select this new mode. If you decide
to cancel the operation then press the key below the Go Back key
label in the smart-key label at the bottom left of the display.