Owner manual
Table Of Contents
- Welcome To Your THZ-100 Thermostat
- Installing Your THZ-100 Thermostat
- Wiring Your THZ-100 Thermostat
- Definitions
- Single Stage Furnace and Single Stage A/C
- Dual Stage Furnace and Dual Stage A/C
- Single Stage Heat Pump with Reversing Valve O
- Single Stage Heat Pump with Reversing Valve B
- Dual Stage Heat Pump with Reversing Valve O
- Dual Stage Heat Pump with Reversing Valve B
- Boiler and A/C with Separate Transformers
- First Stage Radiant Floor Heat, Second Stage Furnace with Single Stage Cooling and External Pilot Duty Relay
- Operation For Your THZ-100 Thermostat
- Thermostat Display Information
- Changing the Heating Temperature (Temperature Override)
- Changing the Cooling Temperature (Temperature Override)
- Auxiliary Heat
- Emergency Heat
- Password Protection
- Programs
- Options
- Climate Modes
- Changing the Fan Modes
- Accessing Temperature Sensor Information
- Turning Emergency Heat On or Off
- Changing the Auxiliary Heat Offset Temperature
- Changing the 2nd Stage Offset Temperature
- Resetting the Filter Reminder
- Turning the Password Protect Feature On or Off
- Changing the LCD Screen Options
- Viewing THZ-100 Thermostat Information
- Setting the Date and Time
- Discovery Mode
- Troubleshooting Thermostat On-Screen Notifications
- Resetting the THZ-100 hermostat
Page 36
THZ-100 THERMOSTAT
Adjusting the LCD Brightness
If you desire to change the brightness of your thermostat LCD
display then use the arrow keys to move the highlight bar to LCD
Brightness.
Press the key below the OK key label in the smart-key label at the
bottom right of the display to select this option. If you decide to
cancel the operation then press the key below the Cancel key label
in the smart-key label at the bottom left of the display.
After pressing OK, the screen updates to a screen that says LCD
Screen Brightness at the top of the screen and the current brightness
level in the center of the screen. Use the arrow keys to adjust the
brightness percentage to the value you desire. As you change the
value of the brightness in the center of the display the brightness
changes to correspond to the level displayed.
When you are satisfied with your brightness level selection then
press the key below the Set Level key label in the smart-key label
box at the bottom right of the display to save your new value. If
you decide to cancel the operation then press the key below the
Cancel key label in the smart-key label at the bottom left of the
display.