Owner manual
Table Of Contents
- Welcome To Your THZ-100 Thermostat
- Installing Your THZ-100 Thermostat
- Wiring Your THZ-100 Thermostat
- Definitions
- Single Stage Furnace and Single Stage A/C
- Dual Stage Furnace and Dual Stage A/C
- Single Stage Heat Pump with Reversing Valve O
- Single Stage Heat Pump with Reversing Valve B
- Dual Stage Heat Pump with Reversing Valve O
- Dual Stage Heat Pump with Reversing Valve B
- Boiler and A/C with Separate Transformers
- First Stage Radiant Floor Heat, Second Stage Furnace with Single Stage Cooling and External Pilot Duty Relay
- Operation For Your THZ-100 Thermostat
- Thermostat Display Information
- Changing the Heating Temperature (Temperature Override)
- Changing the Cooling Temperature (Temperature Override)
- Auxiliary Heat
- Emergency Heat
- Password Protection
- Programs
- Options
- Climate Modes
- Changing the Fan Modes
- Accessing Temperature Sensor Information
- Turning Emergency Heat On or Off
- Changing the Auxiliary Heat Offset Temperature
- Changing the 2nd Stage Offset Temperature
- Resetting the Filter Reminder
- Turning the Password Protect Feature On or Off
- Changing the LCD Screen Options
- Viewing THZ-100 Thermostat Information
- Setting the Date and Time
- Discovery Mode
- Troubleshooting Thermostat On-Screen Notifications
- Resetting the THZ-100 hermostat
Page 39
THZ-100 THERMOSTAT
Press the key below the OK key label in the smart-key label at the
bottom right of the display to change your settings. If you decide to
cancel the operation then press the key below the Go Back key
label in the smart-key label at the bottom left of the display.
The new screen display shows the value that you have selected to
change. Use the Up and Down arrow keys to the right of the
display to select your new value. When you are satisfied with your
new selection, press the key below the Set <parameter> key label
Discovery Mode
The Discovery Mode selection in the Options screen is used to
establish communications between the THZ-100 thermostat and the
MRX Advanced Network System Controller unit for initial setup of
the thermostat and any required updates. This is not used in normal
operation.