Instruction manual

7510/7512
WARNING:
5. Wash body of slicer using warm water and mild soap using a soft clo
th. Under
no circumstances should the slicer be hose rinsed. It is recommended that the
cloth be folded over a thin wooden stick when cleaning between the fence plate
and the knife.
6. Remove knife guard (Figure 1 [7]) by loosening knife guard knob (Figure 3 [2])
and pushing the long stud upward to lift the knife guard above surface of knife.
Then carefully lift and remove guard.
7. Remove Knife deflector (Fig. 3 [19]) by unscrewing Knife deflector screw (Fig.
3 [21]).
WARNING:
8. CAREFULLY wash the
front and rear of the knife with a cloth using warm
water and mild soap. It is recommended that the cloth be folded over a thin
wooden stick as a further caution to avoid accidental contact with the knife.
Rinse with warm water applied with a cloth. Dry th
oroughly with a clean soft
cloth.
WARNING:
9. Following cleaning, a commercial non-toxic sanitizer may be wiped on the
clean surfaces with a soft clean cloth or sprayed as recommended on the
container labeling. It is important that the sanitizer be compat
ible with anodized
aluminum or the clear protective finish on the slicer will be damaged. Surfaces
should be wetted completely, but not to the point of running or puddling.
WARNING:
10. Replace the knife guard. Never leave the slicer without its knife guard installed.
11. Replace Knife deflector.
LUBRICATION
Lubrication instructions are given in Figure 2 on Page 7.
Operator's attention is called to lubricating
the slide bar (Figure 6 [4]) as needed for smooth carriage motion, but at least monthly with
three
drops of mineral oil.
Shafts to the last slice grip and to the auxiliary fence (Figure 5 [7,10]) (Figure 5A [8,12]
should be
lubricated as necessary with petrogel. Distribute over surfaces by moving the grip and fence back and
forth. Wipe excess petrogel, from shafts with a clean cloth.
PAGE 6