Manual

6
3.2 - PACKAGE CHECK UPON RECEIPT
If no external damage is evident on the package upon its arrival, open it and check that all the components are inside
(see FIG. n°3). If the package has suffered rough handling, bumps or crashes, the carrier must be informed about any
damage; moreover a detailed report on the extent of the damage caused to the machine must be filled within three days
from the delivery date shown in the shipping documents. Do not overturn the package!! When the package is
transported, make sure the box is lifted by the 4 corners (parallel to the ground).
3.3 - PACKAGING DISPOSAL
The components of the packaging (cardboard, eventual pallets, plastic straps and polyurethane) are urban solid waste;
therefore they can be easily disposed.
If the machine has to be installed in countries where specific regulations are in force, packaging must be disposed in
compliance with them.
CHAP. 4 - INSTALLATION
4.1 - SETTING UP OF THE MACHINE
The machine must be installed on a working table suitable for its overall dimensions shown in Tab. 1, therefore it must
be adequately large, well levelled, dry, smooth, resistant, stable and placed at a height of 80 cm from the ground.
Moreover the machine must be installed in a room with max. 75% not saline humidity at a temperature between +5°C
and +35°C; that is to say in a place that does not provoke the machine failure.
4.2 - ELECTRICAL CONNECTIONS
The machine is equipped with a power supply cord which section is adequate to the absorb power and a plug.
To connect the machine, follow the indication of the rating plate - serial number (see FIG. n°4).
Check that the earthing is fully operational.
Moreover check that the features on the rating plate - serial number (see FIG. n°4) correspond to the features shown in
the consignment and delivery note, and that the disconnecting plug and the socket are easy to reach when the machine
is functioning.
FIG.n°4 - Rating plate-serial number
4.3 - FUNCTIONING CHECK
To check the machine functioning, just turn the “start” regulator knob clockwise (placing yourself in front of the knob),
and starting from the minimum, observe if the pilot lamp turns on .
When the pilot lamp is on, it means that the machine is functioning.