Manual

7
CHAP. 5 - USE OF THE MACHINE
5.1 - CONTROLS ON THE GRILLERS
The controls are placed on the machine has shown in the figure below.
5.3 - FIRST USE OF THE MACHINE
When the machine is delivered, the steel surfaces are protected with a nylon anti-scratch film. This film has to be
removed accurately before starting the machine and pay attention to remove eventual residuals of glue.
To perform this operation, do not use sharpening tools, inflammable or abrasive substances.
The insulating materials used during the manufacturing and the residuals of grease due to the mechanical installation of
single parts, heat and produce smoke, for this reason, it is necessary to start the machine outside, putting it at the
maximum for 15-20 minutes.
WARNING
: When you place the product on the grid to cook it, this must be hot, so pay attention to residual risks due to
burning dangers.
To load the product follow this procedure:
1. place yourself in a correct position (FIG. n°6), avoiding any contact with the machine;
2. choose the correct temperature using the knob (for the grillers) and regulate the heating intensity for the toasters;
3. when the griller or the toaster is hot, place the product and start the cooking;
4. at the end of the cooking, remove the residuals from the grid;
5. if the griller is inactive for a long period (f.i. one or two hours), place the knob to 0 °C.
2
1
FIG. n°5 - Controls position on the grillers
1 Thermostat
2 Pilot lamp, it indicates that the resistors are on.
FIG. n°6 - Correct position for cooking
"If the machine has been turned off longer than 30 min., allow at least 10 min. for it to reach cooking temperature again.
If you are not using the machine, but you think you are going to need it soon, set the temperature at 120 F, this will allow
the machine to reach cooking temperature faster".