Manual

Pagina 17
10.2 PERIODIC MAINTENANCE
To ensure the machine works properly and, in particular to ensure a long life, you are advised to periodically
clean the ring on the head (see instructions below).
The stainless steel parts, the painted covers, the polyethylene PE500 and the plates in PETG can be easily
cleaned with water and soap or a neutral detergent, then you need to rinse them with plenty of water and dry
them with a soft cloth.
Having removed the upper casing as previously described, continue as illustrated
3. Close the cutting unit
accompanying it to the
support and close the
fastening thrusts (x2)
2. Remove the ring and clean
it inside with a plastic
scraper.
1. Open the cutting unit
accompanying it to the
support.
Remove the ring
fastenings (x2)
x2
7. Close the fastening thrusts
(x2)
8. Place the upper casing by
screwing in the specific
fastenings (x2)
. Check the two fastening thrusts are correctly coupled.
If not, they can cause serious damage to the machine.