Manual

Page 10
The machine must only be installed by qualified and authorised staff.
The machine must only be used for the purpose of dividing dough (rounding for rounding dividers).
The warranty is not valid if changes are made without the manufacturer's authorisation and/or if non-original
spare parts are used. Use of non-original spare parts can damage the machine and/or harm the operator.
The machine must be positioned on a solid and regular floor. The machine is very stable. (For rounding
dividers): if the feet are regulated properly, the machine will be very stable.
6.1 POSITIONING AND MAINTENANCE
6.2 ELECTRICAL CONNECTION
A qualified technician should carry out installation and an electrician should connect the machine to the
power supply system. Firstly check the voltage and the connection phases are equal to those of the
machine (see identification plate). If this is not the case, contact the retailer.
Check the rotation direction of the motor on the machine. Turn the main switch to position I-ON. Close the lid
and do a work cycle "unladen". At the end of the cycle the work plan and the knives should be in the highest
position. If this is not the case, an electrician must invert the phases, i.e. he must invert the two cables in the
power plug to change the rotation direction of the motor.
6.3 DISPOSAL OF THE MACHINE
When you want to dispose of an entire machine, parts or just the packaging, you must comply with the
waste disposal rules. Specifications regarding the material on the various parts can be obtained from the
manufacturer. See WEEE.
6.4 PLACING MACHINE OUT OF SERVICE
Switch off the machine by bringing the main switch to 0-OFF and subsequently protecting the machine from
external factors and leave it in a dry and enclosed location.
6 - INSTALLATION