Troubleshooting guide

SRM2O - SRMF2O
e.
Lubrication of the transmission should be done following its
installation on the mixer. Apply Keystone Nevastane 5P7 grease to
the spur gear and bevel gear meshes. This may be simplified by
feeding the grease into the rotating gear meshes. Caution should be
exercised to avoid entrapment of the application implement in the gear
teeth,
Insure the deflector (Fig. 5 [5]) is positioned to dynamically
guide the lubrication into the bevel gear mesh.
BOWL SUPPORT ASSEMBLY (Fig. 9)
WARNING; Disconnect electrical power for safety.
Remove housing top cover (Fig. 12 [16]), and rear access panel (Fig. 12
[23 j).
Remove four cap screws (Fig. 9 [15]) and remove bowl support (Fig. 9 [1 J)
and slide cover (Fig. 9 [3]).
CAUTION: Bowl support must be held while screws are being removed in
order to prevent it from falling.
Reassembly is the reverse procedure.
SLIDE ASSEMBLY (See Fig. 9)
Carry out above disassembly procedure for removing bowl support.
Remove fixed slide cover (Fig. 12 [6]) by removing two nuts. (Fig. 12 [5])
Remove retaining ring (Fig. 9 [8]) from rod end pin (6). Withdraw pin (6)
from rod end (7).
Remove four kep nuts (Fig. 9 [13]) and withdraw slide frame (5) from
housing studs.
Remove four cap screws (Fig. 9 [14]) and lift off gibbs (Il). Remove slide
(IO).
Clean and inspect sliding surfaces for excessive wear
Replace parts showing excessive wear,
Lubricate sliding surfaces with grease.
Reassemble and reinstall in the reverse of the above procedure,
Check clearance between batter beater and bowl per Mechanics Maintenance
paragraph 3 a-d and readjust as necessary.
Page 8
PDF compression, OCR, web optimization using a watermarked evaluation copy of CVISION PDFCompressor