Manual

Operation manual
Pag. 4/14
VE 160-200-250-300
1. Safe work methods and procedures
In order to prevent hazardous conditions and/or possible injuries caused by: electric current, mechanical parts, fire,
or of hygienic nature, the following safety warnings must be observed:
• Keep your work station tidy. Clutter can cause accidents.
• Assess the environmental conditions. Do not use or leave the machine in a wet, damp or poorly lit environment,
or in the vicinity of flammable liquids or gases.
• Keep children and unauthorised personnel away. Do not allow these people to approach the machines or work
station.
• Use the machine within its operating range and for the purpose for which it was designed. It works best and at
its safest when it is not overloaded.
• Wear appropriate clothing. Do not wear dangling clothes or accessories that may get entangled in moving parts.
Use the shoes with reinforced tip and non-slip sole. For health and safety reasons, long hair should be gathered
in the appropriate net and gloves should be worn.
• Protect the power supply cable. Do not pull the cable to disconnect the plug. Do not expose the cable to high
temperatures, in contact with sharp edges, water or solvents.
• Avoid unsafe positions. Find the most suitable position that ensures absolute stability.
• Always exercise extreme caution.
• Always take the plug out of the socket after use and before cleaning and maintenance and before moving the
machine, and leave it in a clearly visible place.
• Never use extension cables outdoors.
• Make sure that the machine is not damaged. Carefully check the effectiveness of the safety devices before using
the machine. Make sure that: the mobile parts are locked in place, there are no damaged components, all the
parts have been assembled correctly and the machine can be run normally in optimal conditions. (See chapter
14)
• Entrust repairs to qualified personnel. Repairs must only be performed by qualified personnel using original spare
parts.
FAILURE TO OBSERVE THESE REQUIREMENTS MAY BE CAUSE OF HAZARD FOR THE USER.
1.1. Risks for the operator
Gripping and dragging hazard: it is present between bowl and structure, between bowl and
contrast wheels.
Electrocution hazard: the machine must not be used without adequate earthing, and it must be
connected to a system built according to building regulations in force in the country of
installation.
READ THESE INSTRUCTIONS CAREFULLY BEFORE USING THE MACHINE