User's Manual

■ appendix B agency regulatory notices
B-5
Power Cord Requirement
The power cord supplied with the AC adapter should match the plug and
voltage requirements for your local area. Regulatory approval for the AC
adapter has been obtained using the power cord for the local area.
However, if you travel to a different area and need to connect to a different
outlet or voltage, you should use one of the power cords listed below. To
purchase a power cord (including one for a country not listed below) or a
replacement ac adapter, contact your local dealer.
U.S. and Canada
 The cord set must be UL-Listed and CSA-Certified or C-UL Listed.
 The minimum specifications for the flexible cord are (1) No. 18 AWG,
(2) Type SJ, and (3) 3-conductor.
 The cord set must have a rated current capacity of at least 10 A.
 The attachment plug must be an earth-grounding type with a NEMA
5-15P (15A, 125V) or NEMA 6-15P (15 A, 250V) configuration.
Japan
 All components of the cord set (cord, connector, and plug) must bear
a `PSE` mark and registration number in accordance with the
Japanese Dentori Law.
 The minimum specification for the flexible cord are: (1) 0.75 mm
2
conductors, (2) Type VCT or VCTF, and (3) 3-conductor.
 The cord set must have minimum rated current capacity of 7 A.
 The attachment plug must be a two-pole, grounded type with a
Japanese Industrial Standard C8303 (15 A, 125 VAC) configuration.
Other Countries
 The cord set fittings must bear the certification mark of the agency
responsible for evaluation in a specific country. Acceptable agencies
are:
BSI (UK)
OVE (Australia)
CEBEC (Belgium)
SEMKO (Sweden)
FIMKO (Finland)
DEMKO (Denmark)
NEMKO (Norway)
SETI (Finland)
EANSW (Australia)
SEV (Switzerland)
IMQ (Italy)
UTE (France)