Instructions

24 von 96

Stand 4.11.2021

OPERATION

1. Before using the appliance, prepare it as described in the chapter “Before

first use”.

2. Press the opening button on top of the appliance.

3. Add the desired amount of clear and cold water. You need to add at least

0.5 litres of water, but no more than the maximum capacity of 1.5 litres of

water. For easier orientation, you can use the scale found on the inside of

the appliance. Caution: Never fill water past the „Max.“ mark. If you heat

too much water in the appliance, boiling water may be ejected and cause

scalding.

4. Close the lid by pressing lightly until it clicks into place.

5. Connect the base via the power cord to the power supply (220–240 V~,

50/60 Hz).

6. The display lights up and reads “888”, and all function indicators flash

briefly.

7. Next, select one of the following options:

Boil water to 100 °C

8. Press the “ON/OFF” button to switch the appliance on.

9. The display shows “Standard” and “100 °C”, an acoustic signal sounds,

and the appliance starts heating up the water - with no temperature holding

phase. The water is boiled to 100 °C. You can cancel the process at any time

with a press of the “ON/OFF” button

Heat water to 40 °C

10. Press the “Mode” button three times in a row.

11. An acoustic signal sounds, and the appliance starts heating the water to

40 °C - with no temperature holding phase.

12. To turn on the temperature holding phase, press the “Mode” button three

times in a row and hold the button down briefly for another 3 seconds. The

water is heated to 40 °C and then kept at this temperature for a period of

90 minutes