Product data

USRobotics
Command Reference
Data Command Set - 27
1 Enables long-form (verbose) result codes. (Default.)
Result Codes
OK <value> = 0 or 1.
ERROR Otherwise.
W - Connect Message Control
This command, in conjunction with S95 bits 0, 2, 3, and 5 (bits 2, 3, and 5 can be
written directly by the host or by the +MR, +ER, and +DR commands,
respectively), control the format of CONNECT messages (see Table 3-15). The
actual result code messages reported reflect the W command setting and the S95
bit settings. (Also see +MR, +ER, and +DR commands.)
Syntax
W[value>]
Defined Values
<value> Decimal number corresponding to the selected option.
0 Upon connection, the modem reports only the DTE speed (e.g.,
CONNECT 19200). Subsequent responses are disabled.
(Default.)
1 Upon connection, the modem reports the line speed, the error
correction protocol, and the DTE speed, respectively.
Subsequent responses are disabled.
2 Upon connection, the modem reports the DCE speed (e.g.,
CONNECT 14400). Subsequent responses are disabled.
3 Upon connection, the modem reports DCE speed and the error
correction protocol.
Result Codes
OK <value> = 0-3.
ERROR Otherwise.
X - Extended Result Codes
This command selects the subset of the result code messages used by the
modem to inform the DTE of the results of commands.
Blind dialing is enabled or disabled by country parameters. If the user wishes to
enforce dial tone detection, a "W" can be placed in the dial string (see D
command). The information below is based upon the default implementation of
the X results table. Table 3-1 indicates the messages which are enabled for each