Product data

USRobotics
Command Reference
Data Command Set - 75
Example Modem Response and Usage
Example #UD commend response are shown in Table 3-13.
50 AnyKeyAbort Call Control
51 DteHangupCom-
mand
If ATH was used to terminate the previous call.
52 DteResetCom-
mand
If ATZ was used to terminate the previous call.
5A FrameReject Error Control
5B NoErrorCon-
trolEstablished
Error control was required
5C ProtocolViolation
5D n400exceeded LAPM retransmission Count Timer
5E Negotiation-
Failed
5F Disconnect-
FrameReceived
60 SabmeFrameRe-
ceived
64 LossOfSynchro-
nization
Data Compression
Table 3-12: Completed Data Call, with Some Errors and Rate Retrain during the Call
Modem Response line Description
DIAG <2A4D3263 0=09> This is version 0.9
DIAG <2A4D3263 1=06 2=0 3=0> Data Answer signal detected; Data only; Character async
DIAG <2A4D3263
5="C14513902A" 6="A145">
V.8 Call Menu indicates: V.8 Joint Menu selects:
DIAG <2A4D3263 10=1F 11=0C
12=52>
Receive level = -31 dBm; transmit level = -12 dBm; noise level = -82 dBm
DIAG <2A4D3263 14=03 15=05
16=10>
Far end echo delay in milliseconds; Far end echo loss in dB; Near end echo
loss = 16 dB
DIAG <2A4D3263 20=C 22=780
24=0C80 26=79E0>
Transmitter: V.34 training completed; V.34 carrier frequency = 1920; V.34
symbol rate = 3200; initial transmit rate is 31200 bit/s
DIAG <2A4D3263 21=D 25=1F40
27=DAC0>
Receiver: V.90 training completed; V.90 symbol rate = 8000; initial receive
rate is 56000 bit/s
Table 3-11: callCleared codes from 3.6.4/V.58-1994
Value Description Notes