Use and Care Guide

-3-
33"
4-5/8"
23"
FLOOR PROTECTOR
11-3/8"
18-1/2"
26-1/2"
8"
DO NOT BURN:
1. Residential or commercial garbage;
2. Lawn clippings or yard waste;
3. Materials containing rubber, including tires;
4. Materials containing plastic;
5. Waste petroleum products, paints or paint thinners, or asphalt products;
6. Materials containing asbestos;
7. Construction or demolition debris;
8. Paper products, cardboard, plywood, or particleboard. The prohibition against burning these materials does
not prohibit the use of re starters made from paper, cardboard, saw dust, wax and similar substances for the
purpose of starting a re in unaffected wood heater.
9. Railroad ties or pressure-treated wood;
10. Manure or animal remains;
11. Salt water driftwood or other previously salt water saturated materials;
12. Unseasoned wood;
13. Any materials that are not included in the warranty and owner’s manual for the subject wood heater; or
14. Any materials that were not included in the certication tests for the subject wood heater.
Do not burn manufactured logs made of wax impregnated sawdust or logs with any
chemical additives. Manufactured logs made of 100% compressed sawdust can be
burned, but be careful burning too much of these logs at the same time. Start with one
manufactured log and see how the stove reacts. You can increase the number of logs
burned at a time to making sure the temperature never rises higher than 475 °F (246 °C)
on a magnetic thermometer for installation on single wall stove pipes or 900 °F (482 °C)
on a probe thermometer for installation on double wall stove pipe. The thermometer
should be placed about 18” (457 mm) above the stove. Higher temperatures can lead
to overheat and damage your stove.
Tools and Materials Needed
TOOLS
• Pencil
• 6 Foot Folding Ruler or Tape Measure
• Tin Snips
• Drill, Hand or Electric
• Drill Bit 1/8" Dia. (For Sheet Metal Screws)
• Adjustable Wrench
• Screw Driver (Blade-Type)
• Gloves
• Safety Glasses
MATERIALS
• 6" Elbow, Collar and Thimble; As Required (24 gauge
min.)
• 1/2" Sheet Metal Screws (No. 10A x 1/2")
• 6" Diameter, 24 gauge, black or blued steel ue
connector pipe
• Floor Protector Material (R value = 2.06); Size and
Installation as specied in this manual
• Furnace Cement (Manufacturer Recommends:
Rutland Black Code 78 or Equivalent)
• Optional; 6" Barometric Draft Regulator (DR-6)
HEATER DIMENSIONS FIG. 1