User Manual

INSTALLING OTHER FAX/DATA SOFTWARE
64
You can use fax/data software other than
RapidComm (the fax/data software on the
Connections CD). Your modem was
designed for and tested using a wide range of
communications software packages. This
section will guide you through some of the
details you may need to know when installing
other communications software packages.
Type of Modem
Most communications software programs will
ask you to select the type of modem you are
using. Select a U.S. Robotics Sportster high
speed modem. If that selection is not listed,
pick Courier Dual Standard, V.32bis, or
V.34.
KEY POINT: Refer to your software
manual for the program’s installation
instructions. The software’s installation
program will ask you questions about the
modem you are using.
Initialization String
For hardware flow control, a fixed serial port rate
and full result codes, type AT&F1 and press
ENTER. If you must use software flow control,
type AT&F2 and press ENTER.
NOTE: If you use the Modem Station
program to configure your modem, you
must use ATZ for the initialization string.
.