Installation Guide

Installation instructions
Textile care system
J14001113-R04
27/03/2015
1
The appliance should be installed by qualified personnel only.
Each step must be carried out and checked in full in the order specified.
Validity
These installation instructions apply to the model: 14001
Transport
Transport the appliance in an upright position only! Transporting it in any other position will result in dam-
age to the appliance! When carried carefully without being shaken, the appliance may be tilted a maximum
of 90° to the left (viewed from the front).
The appliance must be allowed to stand in the standard operating position for about 2 hours before using
the heat pump. Failure to observe this can result in damage to the appliance.
Front
Front
Side
Front,
upside down
Back
Front
Use a stair
climber trolley to
avoid bumps to the
appliance!!
Identification plate
► Open the appliance door.
– The identification plate is located on the
inside of the appliance door at the top
(see arrow).