Specifications

26.10.2009 Rev. 3.6
Installation
10
5.4 Test-run
Besides the live electrical parts also look out for possible moving mechanisms in the low-
er part of the appliance, if there is a need for testing the appliance during installation while
the guards or cover plates are detached.
Make sure that the protective grease has been removed from the frying surface before tak-
ing the pan into use. See “Preparing the use”.
After connecting the cable check the function of the bratt pan by turning it on with the
ON/OFF button.
Check that
• the temperature displays of both heating zones (only one zone in the model PE 60)
flashes the set reading which after a few minutes stays continuously on.
• the limit switches of the tilting and heating work properly: When tilting the heating
is switched off, in the fully tilted position tilting stops and the power is cut from
the tilting motor. The return movement stops when the pan reaches the base, the
heating is switched on and the power is cut from the tilting motor. If necessary, ad-
just the limit switches.
Before refitting the front siding, check that no wires in the base interfere with moving
parts.
Refit the lower front siding.