Operating Guide

WARNING: TO REDUCE THE RISK OF ELECTRIC SHOCK, UNPLUG BEFORE

TROUBLESHOOTING.

TROUBLESHOOTING

Symptom Possible Causes Corrective Action

Vacuum will not operate

1) No power supply.

1) Check power supply – cord,

breakers, fuses.

2) Faulty power cord.

2) Unplug and check the power

cord. If damaged, have it

repaired by a professional.

3) Collection tank full. 3) Empty collection tank.

Dust comes out from motor

cover.

1) The cartridge lter is missing

or damaged.

1) Attach or replace cartridge

lter.

Reduced efficiency and motor/

speed vibration.

1) There is a blockage in the

nozzle, hose, or the collection

tank inlet. The cartridge lter is

clogged by ne dust.

1) Check nozzle, hose and

collection tank inlets for

blockage. Take off the filter

and clean it or install a new

cartridge lter.

Installing Foam Wet Filter

1. Verify that the power cord is disconnected from the outlet. (Fig.1)

2. Remove power head and place in upside down position. Follow instructions to remove

cartridge lter.

3. Carefully slide foam wet lter down over the lter cage making sure the cage is completely

covered. (Fig. 2 & 3)

4. Place the power head onto the collection tank.

Cleaning Foam Wet Filter

1. With the removed power head in an upside down position, carefully remove foam wet lter. (Fig.

2. Use a mild soap and water solution to wash foam wet lter and rinse with clean water. (Fig. 5)

3. Allow lter to air dry before installing and using again.

INSTALLING & CLEANING FOAM WET FILTER

2 3 4