Operating Guide

GENERAL ASSEMBLY INSTRUCTIONS

WARNING: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT EXPOSE TO RAIN.

MAKE SURE PLUG IS DISCONNECTED BEFORE ASSEMBLING THE WET/DRY VAC.

1. Verify that the power cord is disconnected from the outlet. (Fig. 1)

2. Undo the latches. (Fig. 2)

3. Lift the power head off the collection tank. (Fig. 3)

4. Remove the contents from inside the collection tank; make sure you have all contents as listed

on page 5. (Fig. 4)

5. Turn the collection tank upside down and insert the four caster feet into the slots on the

collection tank and tighten with supplied screws. Verify that the casters are mounted correctly.

Do not over-tighten screws. (Fig. 5)

6. Position the hose storage rack as illustrated. Fully insert one end of the hose storage rack

into the slot illustrated by the arrow, then pull the other end of the hose storage rack to align

with the corresponding arrow and insert into the slot until it is secured in place. (Fig. 6a - 6d)

7. Your vacuum comes ready for dry vacuum cleaning. For installation instructions, see page 11.

8. For wet vacuum cleaning, install the supplied foam wet lter. See page 12 for lter installation.

9. Place the power head back on the collection tank, and secure into place using the 2 side

latches. (Fig. 7 & 8)

10. Insert the locking end of the hose into the port on the collection tank and turn to lock into

place. (Fig. 9)

11. Choose the desired accessory and insert onto the end of the hose. (Fig. 10)

NOISE DIFFUSER

For quiet operation, install the noise diffuser into the blower port by inserting the locking end of the

diffuser into the blower port and turning clockwise to lock into place.

POLARIZED PLUG

To reduce the risk of electrical shock, this appliance has a polarized plug (one blade wider than

the other). This plug will t in a polarized outlet only one way. If the plug does not t fully in the

outlet, reverse the plug. If it still does not t, contact a qualied electrician to install the proper

outlet. Do not change the plug in any way. Double insulation eliminates the need for the

three wire grounded power cord and grounded power supply system.

A Philips head screw driver is required.

UNPACKING YOUR WET/DRY VACUUM & GENERAL ASSEMBLY