Operating Guide

1. Verify that the power cord is disconnected from the outlet. (Fig. 1)

2. In order to prepare your vacuum for dry vacuuming, verify that the cartridge lter is securely

mounted. Make sure the lter is pushed in until it stops against the power head. Your Wet/Dry

Vac comes with the cartridge lter pre-installed. For installation instructions, see page 11.

3. Optional: For improved dust ltering, t collection bag ange onto the inlet port, taking care not

to damage the bag. Dust bag sold separately.

4. Place the power head back on the collection tank, aligning the top section with the latches, and

snap into place. (Fig. 2)

OPERATING INSTRUCTIONS: DRY VACUUMING

5. Insert the locking end of the hose into the vacuum port and lock in place. (Fig. 3).

6. Choose the desired accessory and insert onto the end of the hose. (Fig. 4)

7. Plug the power cord into the outlet. (Fig. 5)

8. Turn the motor on by ipping the power switch to the ‘I’ (ON) position and begin vacuuming. (Fig.

9. Once you have completed vacuuming, ip the power switch to the ‘O’ (OFF) position and

unplug the power cord from the outlet.

O = OFF I = ON

DO NOT USE THE CARTRIDGE FILTER FOR LIQUID VACUUMING.

DO NOT USE DUST BAG FOR LIQUID VACUUMING.

DRY VACUUM OPERATION

WARNING: BE SURE TO READ, UNDERSTAND, AND APPLY, INFORMATION ENTITLED

‘SAFETY INSTRUCTIONS & WARNINGS’. DO NOT VACUUM IN AREAS WITH FLAMMABLE

GASES, VAPORS, OR EXPLOSIVE DUSTS IN THE AIR. FLAMMABLE GASES OR VAPORS

INCLUDE BUT ARE NOT LIMITED TO: LIGHTER FLUID, SOLVENT TYPE CLEANERS, OIL-

BASED PAINTS, GASOLINE, ALCOHOL, OR AEROSOL SPRAYS. EXPLOSIVE DUSTS

INCLUDE BUT ARE NOT LIMITED TO: COAL, MAGNESIUM, GRAIN, OR GUN POWDER.

TO REDUCE THE RISK OF HEALTH HAZARDS FROM VAPORS OR DUST, DO NOT

VACUUM TOXIC MATERIALS.

WARNING: DO NOT PLUG POWER CORD INTO POWER OUTLET. MAKE SURE PLUG IS

DISCONNECTED BEFORE CHANGING THE FILTERS.

CAUTION:

Do not vacuum drywall dust, replace soot, or ash with a standard Wet/Dry lter.

This is a very ne dust which will not be captured by the lter and may cause damage to the

motor. When vacuuming ne dust, use a ne dust lter (included). To purchase the additional

ne dust lters, call 1-866-384-8432 or get them at your local or online Vacmaster

retailer.

DRY VACUUMING