Use and Care Manual
11
1. Verify that the power cord is disconnected from the outlet. (Fig. 1)
2. Disconnect the hose from the vacuum. (Fig. 2)
3. Undo the latches and remove the power head from the collection tank. (Fig. 3) Place power
head on a soft, clean surface upside down.
4. Clear all dirt or debris from the collection tank and hose into a proper waste container. (Fig. 4)
5. Clean or replace the lters.
6. Check the hose, attachments, and power cord to verify that they have not been damaged.
7. Place power head on collection tank and secure latches.
IMPORTANT! Clean or change the lter regularly for best performance. ALWAYS USE DUST
FILTER FOR DRY VACUUMING. If the machine is used without the dust lter, the motor will burn
out and the warranty will be voided. Always keep spare dust lters on hand.
NOTICE! The lter included is made of high quality material designed to stop small dust particles.
The lter should be used for dry pick-up only. A dry lter is necessary to pick up dust. If the
dust lter is wet, it will clog quickly and be very difcult to clean. Handle the lter carefully when
removing it for cleaning and replacing it. Check the lters for tears or small holes, a small hole
can let dust pass through and out of the lter. Do not use a lter with holes or tears; replace it
immediately.
MAINTENANCE
WARNING:
ALWAYS DISCONNECT THE PLUG FROM THE POWER OUTLET BEFORE
REMOVING THE POWER HEAD FROM COLLECTION TANK.
WARNING:
ALWAYS DISCONNECT THE PLUG FROM THE POWER OUTLET BEFORE
REMOVING THE POWER HEAD FROM THE COLLECTION TANK.
4
1
2
3
2 3 4 1
EMPTYING THE COLLECTION TANK
CLEAN THE BLOWER INTAKE
After using the blower, examine the bottom of the blower for debris and blockages and remove if
found. To clean the foam pad of the intake: