Use and Care Manual

INSTALLING & CLEANING

FOAM WET FILTER

Installing Foam Wet Filter

1. Verify that the power cord is disconnected from the outlet. (Fig. 1)

2. Remove power head and place in upside down position. Follow instructions to remove cartridge

lter.

3. Carefully slide foam wet lter down over the lter cage making sure the cage is completely

covered. (Fig. 2 & 3)

4. Place the power head onto the collection tank.

Cleaning Foam Wet Filter

1. With the removed power head in an upside down position, carefully remove foam wet lter. (Fig.

2. Use a mild soap and water solution to wash foam wet lter and rinse with clean water. (Fig. 5)

3. Allow lter to air dry before installing and using again.

1 2 3 4

TROUBLESHOOTING

WARNING:

TO REDUCE THE RISK OF ELECTRIC SHOCK, UNPLUG BEFORE

TROUBLESHOOTING.

Symptom Possible Causes Corrective Action

Vacuum will not operate

1) No power supply. 1) Check power supply – cord,

breakers, fuses.

2) Faulty power cord. 2) Unplug and check the

power cord. If damaged,

have it repaired by a

professional.

3) Collection tank full. 3) Empty collection tank.

4) Switch in the wrong position. 4) Press the ON ‘I’ button on

the power head.

Dust comes from motor cover.

1) The cartridge lter is

missing or damaged.

1) Attach or replace the

cartridge lter.

Reduced efciency and motor/

speed vibration.

1) There is a blockage in the

nozzle or hose, or the

collection tank inlet. Or dust

lter blocked by ne dust.

1) Take off the lter and clean it

or install a new cartridge

lter.