Warranty

1 1
I n s t a l l i n g C a r t r i d g e F i l t e r
1. Verify that the power cord is disconnected from the outlet. (Fig. 1)
2. Remove power head and place in upside down position.
3. Install the cartridge lter over the lter cage with the at end of the lter towards the power
head. Carefully push lter in until it stops against the power head. (Fig. 2 & 3)
4. Place lter retainer on top of cartridge lter over the raised lip and tighten down by turning
retainer clockwise; do not over-tighten. (Fig. 4 & 5)
R e m o v i n g a n d C l e a n i n g C a r t r i d g e F i l t e r
1. Unlock and remove the lter retainer by turning retainer handle counter clockwise.
2. Carefully hold and pull the cartridge lter up for removal. (Fig. 6)
3. Clean the cartridge lter by gently tapping or brushing dirt off. Cleaning should not be done
indoors in living areas. For optimal performance a new lter is recommended.
4. Install cleaned or new lter into place as above in steps 2 and 3 of Installing Cartridge Filter.
5. Wet lters should be removed and allowed to air dry for 24 hours before installing onto the lter
cage.
I M P O R T A N T ! Clean or change the cartridge lter regularly for best performance.
A L W A Y S U S E C A R T R I D G E F I L T E R F O R D R Y V A C U U M I N G . If the machine is used without the
cartridge lter, the motor will burn out and the warranty will be voided. Always keep spare lters on
hand.
W A R N I N G : A L W A Y S D I S C O N N E C T T H E P L U G F R O M T H E P O W E R O U T L E T B E F O R E
R E M O V I N G T H E P O W E R H E A D F R O M T H E C O L L E C T I O N T A N K .
INSTALLING & CLEANING CARTRIDGE FILTER
2 3 4 5 61