Warranty
1 2
W A R N I N G : T O R E D U C E T H E R I S K O F E L E C T R I C S H O C K , U N P L U G B E F O R E
T R O U B L E S H O O T I N G .
TROUBLESHOOTING
S y m p t o m P o s s i b l e C a u s e s C o r r e c t i v e A c t i o n
Vacuum will not operate
1) No power supply.
1) Check power supply – cord,
b reakers, fuses.
2) Faulty power cord.
2) Unplug and check the power
cord. I f damaged, hav e it
rep aired b y a p rofessional.
3) Collection tank full. 3) Empty collection tank.
Dust comes out from motor
cove r.
1) The cartridge lter is missing
or damaged.
1) Attach or replace cartridge
lter.
Reduced efficiency and motor/
sp eed vi b ration.
1) There is a blockage in the
nozzle, hose, or the collection
tank inlet. The cartridge lter is
clogged by ne dust.
1) Check nozzle, hose and
collection tank inlets for
b lockage. Take off the filter
and clean it or install a new
cartridge lter.
I n s t a l l i n g F o a m W e t F i l t e r
1. Verify that the power cord is disconnected from the outlet. (Fig.1)
2. Remove power head and place in upside down position. Follow instructions to remove
cartridge lter.
3. Carefully slide foam wet lter down over the lter cage making sure the cage is completely
covered. (Fig. 2 & 3)
4. Place the power head onto the collection tank.
C l e a n i n g F o a m W e t F i l t e r
1. With the removed power head in an upside down position, carefully remove foam wet lter. (Fig.
4)
2. Use a mild soap and water solution to wash foam wet lter and rinse with clean water. (Fig. 5)
3. Allow lter to air dry before installing and using again.
INSTALLING & CLEANING FOAM WET FILTER
2 3 4
5
1