Warranty
6
GENERAL ASSEMBLY INSTRUCTIONS
W A R N I N G : T O R E D U C E T H E R I S K O F E L E C T R I C S H O C K , D O N O T E X P O S E T O R A I N .
M A K E S U R E P L U G I S D I S C O N N E C T E D B E F O R E A S S E M B L I N G T H E W E T / D R Y V A C .
1. Verify that the power cord is disconnected from the outlet. (Fig. 1)
2. Undo the latches. (Fig. 2)
3. Lift the power head off the collection tank. (Fig. 3)
4 . Remov e the contents from inside the collection tank; make sure y ou hav e all contents as listed
on page 5. (Fig. 4)
5. Turn the collection tank upside down and insert the four caster feet into the slots on the
collection tank and tighten with supplied screws. Verify that the casters are mounted correctly.
Do not over-tighten screws. (Fig. 5)
6. Position the hose storage rack as illustrated. Fully insert one end of the hose storage rack
into the slot illustrated by the arrow, then pull the other end of the hose storage rack to align
with the corresponding arrow and insert into the slot until it is secured in place. (Fig. 6a - 6d)
7 . Y our va cuum comes ready for dry va cuum cleaning. For installation instructions, see p age 1 1 .
8. For wet vacuum cleaning, install the supplied foam wet lter. See page 12 for lter installation.
9. Place the power head back on the collection tank, and secure into place using the 2 side
latches. (Fig. 7 & 8)
1 0 . I nsert the locking end of the hose into the p ort on the collection tank and turn to lock into
place. (Fig. 9)
11. Choose the desired accessory and insert onto the end of the hose. (Fig. 10)
N O I S E D I F F U S E R
For quiet operation, install the noise diffuser into the blower port by inserting the locking end of the
diffuser into the blower port and turning clockwise to lock into place.
P O L A R I Z E D P L U G
To reduce the risk of electrical shock, this appliance has a polarized plug (one blade wider than
the other). This plug will t in a polarized outlet only one way. If the plug does not t fully in the
outlet, reverse the plug. If it still does not t, contact a qualied electrician to install the proper
outlet. Do not change the plug in any way. Double insulation eliminates the need for the
three wire grounded power cord and grounded power supply system.
A Philips head screw driver is required.
1
10
3
8
9
2
5
4
7
6 d
6 a
6 b
6 c
U N P A C K I N G Y O U R W E T / D R Y V A C U U M & G E N E R A L A S S E M B L Y