User Manual

MAINTENANCE

INSTALLING HEPA FILTER AND

PRE-FILTER

WARNING: ALWAYS DISCONNECT THE PLUG FROM THE POWER OUTLET BEFORE

REMOVING THE POWER HEAD FROM THE CONTAINER.

1. Verify that the power cord is disconnected from the outlet. (fig. 1)

2. Disconnect the hose from the vacuum. (fig. 2)

3. Undo the latches and remove the power head from the container. (fig. 3)

4. Clear all dirt or debris from the container and hose. (fig. 4)

5. Clean the foam filter by washing it with water and mild soap. (fig. 5)

6. Check the hose, attachments, and power cord to verify that they have not been damaged.

is fitted with a float valve that stops the suction action when the container reaches its maximum

capacity. You will notice an increase in motor speed. When this happens, turn off the machine,

disconnect from power supply, and drain the liquid into a suitable receptacle or drain. To continue

vacuuming, refit the container with the drain cap. After wet vacuuming, turn the machine off and

remove plug from power supply. Empty the container, clean and dry the inside and outside before

storage.

REMEMBER! The foam filter must be removed after wet vacuuming, and the HEPA filter must

be reinstalled before dry vacuuming again.

4 5