User Manual

DRY VACUUM
12
INSTALLING & CLEANING FOAM
SLEEVE FILTER
Installing HEPA Filter and Pre-Filter
1. Verify that the power cord is disconnected from the outlet. (fig. 1)
2. Remove power head and place in upside down position.
3. Install the HEPA filter over the filter cage with the flat end of the filter towards the vacuum power
head. Carefully push filter in until it stops against the power head. (fig. 2 )
4. Place filter retainer on top of cartridge filter over the raise lip and tighten down by turning retainer
Clockwise, do not over tighten. (fig. 3)
5. Slide the pre-filter onto the assembled HEPA filter, over the lower end cap. Tighten the band
clamp on the pre-filter with a screwdriver to ensure proper installation. (fig. 4 & 5)
Removing HEPA Filter and Pre-Filter
1. Loosen the band clamp on the pre-filter with a screwdriver, and remove the pre-filter from the
HEPA filter.
2. Unlock and remove the filter retainer by tuning retainer counter clockwise.
3. Carefully hold and pull the HEPA filter up for removal. (fig. 6)
4. Install the HEPA filter into place as instructed above in steps 2 and 3 of Installing HEPA filter.
6. Wet filter should be removed and allowed to air dry for 24 hours before installing onto the filter
cage.
IMPORTANT! Change the cartridge filter regularly for best performance. ALWAYS USE THE
HEPA FILTER FOR DRY VACUUMING. If the machine is used for dry vacuuming without the HEPA
filter and retainer attached, the motor will burn out and the warranty will be voided.
NOTICE! The HEPA cartridge filter included is made of high quality materials designed to stop
small dust particles. The HEPA cartridge filter should be used for dry pick-up only. A dry HEPA
cartridge filter is necessary to pick up dust. If the HEPA cartridge filter is wet, it will clog quickly and
be very difficult to clean. Handle the HEPA cartridge filter carefully when removing it for replacing it.
Check the HEPA cartridge filter for tears or small holes, a small hole can let dust pass through and
out of the cleaner. Do not use a HEPA cartridge filter with holes or tears, replace it immediately.
Installing Foam Sleeve Filter
1. Verify that the power cord is disconnected from the outlet. (fig. 1)
2. Remove power head and place in upside down position. Follow instructions to remove cloth filter.
3. Carefully slide foam sleeve filter down over the filter cage making sure the whole cage is covered.
(fig. 2 & 3)
4. Replace the power head on to the container.
Cleaning Foam Sleeve Filter
1. With the removed power head in the upside down position, carefully remove foam sleeve filter.
(fig. 4)
2. Use a mild soap and water solution to wash foam sleeve filter and rinse with clean water. (fig. 5)
3. Allow filter to air dry before installing and using again.
5
2 43
1