User Manual

7
GENERAL ASSEMBLY INSTRUCTIONS
A Philips head screw driver is required.
WARNING:
DO NOT PLUG IN POWER CORD TO POWER OUTLET, MAKE SURE PLUG IS
DISCONNECTED BEFORE ASSEMBLING THE WET/DRY VAC.
CAUTION: This vacuum has been specifically designed to clean up hazardous dust. Special
filters reduce the incidence of airborne dust that would be created by other methods of cleaning.
During the removal of hazardous dust, DO NOT sweep, scoop, shovel or in any manner handle
other than by vacuuming. DO NOT at any time attempt to remove, substitute or by any other means
change the filters in the vacuum. Use only manufacturer’s approved vacuum filters and filters bags.
Before attempting to use or before cleaning with this vacuum, be sure that you fully understand the
instructions for setting up or cleaning/changing filters. Any health hazards associated with use of
this vacuum in conjunction with the removal of hazardous material has not been investigated by
Underwriters Laboratories, Inc.
The hepa vacuum is supplied with a certified hepa filter that Has been lot tested by independent lab to
IEST-RP-CC001 that meet the epa definition of a hepa vacuum (100% leak tested to 99.97% @ 0.3
micron Efficiency). It can be used for lead renovation work under the epa’s lead Ppr rule. It can be
used to pick up materials like sawdust and gravel, as Well as the ultra fine materials like drywall dust
and cold fireplace ash.
1
3
4
5
7
8
9
15
11
14
6
O P R Q
R
N N N N
R O
10
12
2
13