User Manual

DRY-VACUUM OPERATION

UNPACKING YOUR WET/DRY VACUUM & GENERAL ASSEMBL

1. Verify that the power cord is disconnected from the outlet. (fig. 1)

2. Undo the latches. (fig. 2)

3. Lift the power head off the tank. (fig. 3)

4. Remove the contents from inside the tank, make sure you have all contents as listed on page 6.

(fig. 4)

5. Turn the tank upside down and insert the two caster feet into the front slots on the base.

Apply downward pressure to each caster. Casters will "snap" into place when installed properly.

Verify that the casters are mounted correctly. (fig. 5)

6. Insert the wheel axle into the base. Insert washer onto the axle followed by rear wheel

and insert washer again. Insert the ‘R’ locking pin into the hole on the end of the axle to

lock the wheel. Snap the hub cap on to the wheel. Repeat the same steps at the other end

of the axle. (fig. 6)

7. Your vacuum comes ready for dry vacuum cleaning. If HEPA filter and pre-filter are not installed

refer to page 11 for filter installation.(fig. 7 & 8)

8. Fit collection bag flange onto the inlet stub, taking care not to damage the bag. (fig. 11)

9. For wet vacuum cleaning, remove the pre-filter, HEPA filter and collection bag, install the

supplied foam filter. (fig. 12) See page 12 for filter installation.

10. Place the power head back on the tank, aligning the top section with the latches, and hook

the latches. (fig. 13)

11. Insert the locking end of the hose into the vacuum port and turn to lock in to place. (fig. 14)

12. Choose the desired accessories and push onto the suction tube. (fig. 15)

WARNING: IF FILTERS ARE CONTAMINATED OR HAVE BEEN USED, THEY MUST BE

DISPOSED OF PROPERLY, PRIOR TO PERFORMING WET VACUUMING OPERATIONS.

LIGHTED PLUG

This vacuum comes standard with a lighted plug that when plugged in lights up showing user that

wall receptacle is working and that vacuum has power.

DRY VACUUM