User Manual

9
CAUTION: NEVER operate the vacuum cleaner without all of the filters installed. This includes
the HEPA filter, pre-filer and collection bag. Motor damage, lose of operating efficiency and
recirculation of hazardous material into the work area will take place if not installed.
1. Verify that the power cord is disconnected from the outlet. (fig. 1)
2. In order to prepare your vacuum for dry vacuuming, verify that the HEPA filter is securely
mounted. With power head removed and in upside down position, make sure the filter is pushed in
until it stops against the power head and the rubber flat washer and retainer are installed. (fig. 2 & 3)
3. Slide the pre-filter onto the assembled HEPA filter. Tighten the band clamp on the pre-filter with a
screwdriver to ensure. (fig. 4 & 5) (Your Wet/Dry Vac comes with the HEPA filter and pre-filter
pre-installed, if not, see page 11 for installation instructions.)
4. Optional, for improved dust collecting, fit collection bag flange onto the inlet stub, taking care not
to damage the bag. (fig. 6)
5. Place the power head back on the container, and secure it in place using the latches. (fig. 7)
OPERATING INSTRUCTIONS: DRY VACUUMING
1. Insert the locking end of the hose into the vacuum port and lock in place. Push the required
attachment onto the free end of the hose or extension. (fig. 8)
2. Plug in the power cord into the outlet. (fig. 9)
3. Turn the motor on by flipping the switch to the ‘I’ ON position. (fig. 10)
4. Once you have completed vacuuming, flip the switch to the ‘O’ OFF position and unplug the power
cord from the outlet.
O = OFF I = ON
WARNING: IF FILTERS ARE CONTAMINATED OR HAVE BEEN USED, THEY MUST BE
DISPOSED OF PROPERLY, PRIOR TO PERFORMING WET VACUUMING OPERATIONS.
DO NOT USE THE HEPA FILTER FOR LIQUID VACUUMING.
Hazardous materials must be disposed of properly. NEVER throw contaminated debris in your usual
trash receptacle. Place debris in a OSHA approved poly bag or container marked with HAZARDOUS
MATERIAL warning and dispose in accordance with your local Hazardous Waste Regulations.
WARNING: BE SURE TO READ, UNDERSTAND, AND APPLY INFORMATION, ENTITLED
‘SAFETY INSTRUCTIONS & WARNINGS’. DO NOT VACUUM IN AREAS WITH FLAMMABLE
GASES, VAPORS, OR EXPLOSIVE DUSTS IN THE AIR. FLAMMABLE GASES OR VAPORS
INCLUDE BUT ARE NOT LIMITED TO; LIGHTER FLUID, SOLVENT TYPE CLEANERS,
OIL-BASE PAINTS, GASOLINE, ALCOHOL OR AEROSOL SPRAYS. EXPLOSIVE DUSTS
INCLUDE BUT ARE NOT LIMITED TO; COAL, MAGNESIUM, GRAIN OR GUN POWDER. TO
REDUCE THE RISK OF HEALTH HAZARDS FROM VAPORS OR DUST, DO NOT VACUUM
TOXIC MATERIALS.