Product Manual B
14
INSTALLING & CLEANING
CARTRIDGE FILTER
INSTALLING & CLEANING
FOAM SLEEVE FILTER
Installing Cartridge Filter
1. Verify that the power cord is disconnected from the outlet. (g. 1)
2. Remove power head and place in upside down position.
3. Install the cartridge lter over the lter cage with the at end of the lter towards the vacuum
power head. Carefully push lter in until it stops against the power head. (g. 2 & 3)
4. Place lter retainer on top of cartridge lter over the raised lip and tighten down by turning
retainer clockwise, taking care not to over tighten. (g. 4 & 5)
Removing and Cleaning Cartridge Filter
1. Unlock and remove the lter retainer by turning retainer handle counterclockwise.
2. Carefully remove the cartridge lter by sliding it off of the lter cage. (g. 6)
3. Clean the cartridge lter by gently tapping or brushing dirt off. Cleaning should not be done
indoors in living areas. For optimal performance a new lter is recommended.
4. Install cleaned or new lter as instructed above in steps 2 and 3 of Installing Cartridge Filter.
5. Wet lters should be removed and allowed to dry for 24 hours before installing onto the lter
cage.
Installing Foam Sleeve Filter
1. Verify that the power cord is disconnected from the outlet. (g. 1)
2. Remove power head and place in upside down position. Follow instructions to remove cartridge
lter in the section above.
3. Carefully slide foam sleeve lter down over the lter cage making sure the whole cage is
covered. (g. 2 & g. 3)
4. Replace the power head onto the container.
Cleaning Foam Sleeve Filter
1. With the removed power head in the upside down position, carefully remove foam sleeve lter.
(g. 4)
2. Use a mild soap and water solution to wash foam sleeve lter and rinse with clean water. (g. 5)
3. Allow lter to air dry before installing and using again.